Contents: Corsa Models ⬇ Meriva Models ⬇
Corsa Models
1. Disconnect the cable from the negative terminal of the battery (see Chapter 5).
2. Remove the trim of the corresponding door (see Section 23).
3. Separate the insulating film from the door frame as much as necessary to clear access to the relevant parts.
4. On the rear door, remove the inner door handle (see Section 21). Using a drift, knock out the rivets on the rear door lock release button lever, disconnect the lever and cable holder from the door assembly.
5. On the rear door, remove the glass guide.
6. Disconnect the window lifter motor wiring connector (see accompanying illustration).
18.6. Nuts (indicated by arrows B) mounting cup (2) for external door handle (corsa models) - arrow A indicates the direction of disconnection of the electrical wiring connector: 1. Electrical wiring connector; 3. Door handle rod; 4. Lock cylinder rod
7. On the front door, loosen the 2 nuts and remove the outer door handle mounting cup (see illustration 18.6).
Note: On the rear door, to remove the outer handle, you also need to remove the mounting cup.
8. On the front door, release and separate the door handle rod from the lock latch and the drive rod from the lock cylinder housing (see illustration 18.6).
9. Remove 3 screws on the rear end wall of the door (see accompanying illustration) and separate the lock from the door frame.
18.9. Screws (indicated by arrows) side door lock fasteners
10. Disconnect the cable from the inner door handle and the lock release button (see accompanying illustration).
18.10. Cable (6) for the drive of the inner door handle and the door lock release button
11. Installation is performed in the reverse order of removal. If necessary, replace the insulating film. Pay attention to the reliability of the cables and rods. Without slamming the door, check the operation of the locking mechanism.
Meriva Models
12. Disconnect the cable from the negative terminal of the battery (see Chapter 5).
13. Remove the door trim (see Section 23).
14. Separate the insulating film from the door frame as much as necessary to clear access to the relevant parts.
15. Pull up the retainer and disconnect the electrical wiring connector of the window lifter motor on the door lock (see accompanying illustration).
18.15. Lock (1) of connector (2) of electrical wiring (meriva models)
16. Remove the 3 screws on the rear end wall of the door and separate the lock from the door frame (see illustration 18.9).
17. Disconnect the cable from the inner door handle and the lock release button (see illustration 18.10).
18. Installation is performed in the reverse order of removal. Replace the insulating film if necessary. Without slamming the door, check the operation of the locking mechanism.
Visitor comments