1. Disconnect the wire from the terminal «minus» battery.
2. Remove console trim (see Removal and installation of floor tunnel lining).
3. Slide to the sides of the lining of the handles for adjusting the amount of air supplied through the central nozzles of the heating and air conditioning system.
4. Turn out four bolts of fastening of the block of management of the radio tape recorder and system of heating and air-conditioning …
5.... then move the unit away from the instrument panel.
6. Squeeze the tabs..
7.... and disconnect the wiring harness pads from the control unit for the car radio and the heating and air conditioning system.
8. Remove the block.
9. Turn out two bolts of fastening of an autoradio tape recorder..
10.... and remove it from the socket in the instrument panel.
11. Pull out the latch..
12.... and disconnect the antenna cable block from the radio.
13. By pressing the lock of the lock of the wiring harness block..
14.... unfasten the latch..
15.... disconnect the wiring harness block from the car radio..
16.... and remove the car radio.
17. Install the parts in the reverse order of removal.
Visitor comments