The reverse light switch is located on top of the gearbox housing.
You will need a key «at 22».
1. Disconnect the wire from the terminal «minus» battery.
2. Squeeze the latch..
3.... and disconnect the wiring harness block from the switch.
4. Remove the reverse light switch from the gearbox housing.
5. Remove the O-ring. Replace a heavily compressed ring with a new one.
6. To test the switch, connect a tester in ohmmeter mode to its terminals. The resistance should tend to infinity. Press the plunger of the switch - the resistance should drop to zero. Otherwise, the switch is defective and must be replaced.
7. Install the parts in the reverse order of removal.
Visitor comments