2. Remove the battery from the tray (see chapter 5).
3. Using a flat-blade screwdriver, release the lock and carefully pry the end of the cable out of the support bracket, then disconnect the cable from the retaining plate at the front of the actuating arm (see resist. illustration).
4. At the corresponding complete set release a clamp and accurately separate a cable tip from the AT selector lever. Release the cable sheath from the support bracket.
5. Walk along the cable from the transmission and release it from all provided intermediate clamps without removing the rubber grommet from the bulkhead of the engine compartment.
6. Check the condition of the cable - the cable should move freely in the sheath.
Note: A cable removed from the vehicle may look and function well, but begin to bind when bent.
Replace cable if necessary.
7. Installation is made in an order, the return to an order of removal.
Note: To facilitate the pulling of the cable through the bushing, pre-lubricate it with soapy water.
Adjust the cable (see section 2). Reinstall all removed components.
Visitor comments