Right o-ring
1. Remove the crankshaft pulley.
2. Drill two small holes into the O-ring, located at diametrically opposite ends of the seal. Insert two self-tapping screws into the drilled holes in the O-ring and use pliers to pull the O-ring out past the screw heads.
3. Clean the sealing ring seat.
4. Lubricate the lips of the new O-ring with clean engine oil and install it on the crankshaft. The sealing lips of the new O-ring must face inwards.
5. Remove all traces of engine oil and install the pulley on the crankshaft.
Left O-ring
6. Remove flywheel.
7. Drill two small holes into the O-ring, located at diametrically opposite ends of the seal. Insert two self-tapping screws into the drilled holes in the O-ring and use pliers to pull the O-ring out past the screw heads.
8. Clean the sealing ring seat.
9. Lubricate the lips of the new O-ring with clean engine oil and install it on the crankshaft. The sealing lips of the new O-ring must face inwards.
10. Install the flywheel.
Visitor comments