Removing
1. Install the car over a viewing hole.
2. Remove system of release of the fulfilled gases.
3. Unscrew the heat shield to access the handbrake lever compensator. Release the handbrake lever, move the compensator forward and disconnect the front handbrake cable.
4. Inside the vehicle, remove the center console and handbrake lever guard.
5. Unscrew the adjusting nut from the front of the front handbrake cable and remove the cable from the handbrake lever.
6. Unscrew the nuts securing the handbrake lever (arrows), disconnect the electrical connector and remove the lever from the vehicle.
Installation
Installation is made in sequence, return to removal. In this case, it is necessary to adjust the hand brake.
Visitor comments