Removing
Open the hood.
Disconnect the battery.
Disconnect the ground connector from the ground terminal.
Remove the engine cover.
Remove damping fuel return housing.
Remove the fuel return line from the KM-796-A special tool.
Remove 2 hoses.
Remove 2 clamps.
Disconnect the oil line.
Remove 2 bolts (arrows in the picture).
Note. If the oil line is disconnected from the damping housing, it must be replaced with a new one.
Remove 4 oil lines.
Remove 4 clamps (arrows in the picture)
Installation
Install the oil line.
Connect 4 oil lines to the fuel injectors.
Attach damping fuel return housing.
Connect the oil line.
Connect the fuel return line.
Attach 2 hoses.
Install 2 clamps.
Tighten 2 bolts to 9 Nm.
Install the engine cover.
Connect the battery.
Connect the ground connector to the ground terminal.
Program the volatile memory.
Close the hood.
Visitor comments