Removal and installation the activated carbon container (Opel Corsa C)

Removal

Disconnect the lines using the special tool KM-796-A.

Remove the front right wheel

Remove the protective trim, wing,

Disconnect the wiring harness connector from the turn signal lamp on the fender and remove the turn signal lamp

Loosen the mounting bolt (arrow) and remove the container with activated carbon.

Installation

Install a container with activated carbon and secure it to the body.

Install the turn signal lamp on the fender and connect the wire harness connector to the turn signal lamp.

Install the protective trim, wing.

Install the wheel, tighten the mounting bolts to a torque of 110 Nm.

[Original article on the web portal Opelbook.ru]

Connect the lines.