Attention! The ball joint is attached to the suspension arm with rivets at the factory. If the "factory" support is removed, the rivets are drilled out and replaced with bolts.
1. Remove the suspension arm. If the rivets are replaced with bolts, it is recommended to only disconnect the arm from the steering knuckle, unscrew the bolts and remove the support.
2. Using a 12 mm drill, drill out 3 rivets on the machine (see photo).
3. Install the new support, securing it with special bolts and nuts (purchased at the OPEL car service).
4. Installation of the ball joint is performed in the reverse order.
Visitor comments