Front bumper
1. Remove the three clips that secure the bumper to the front mudguard by pressing on the center pins.
2. Loosen the screws and latches that secure the fender guards to the sides of the bumper (see photo).
3. While holding the bumper with an assistant, remove the plugs and unscrew the 3 upper screws securing the bumper to the front bulkhead (see photo).
4. Give a bumper forward for lateral parts and remove. On models with fog lights and headlight washers, disconnect the wires as you remove the bumper. On part of the car, disconnect the wire from the ambient air temperature sensor (see photo).
5. Installation is carried out in the reverse order.
Rear bumper
6. Open the back cover.
7. Working under the vehicle, remove the screws securing the bumper to the rear bulkhead (see photo). While holding the bumper, remove the 2 screws at the back of the rear fender skid plate and the top screws securing the bumper (see photo). With two people, push the bumper by the side parts and remove from the guides. On Zafira models with a hitch, the coulters must be disconnected (to access the coulter mounts, retract the sliders and remove the cover).
Visitor comments