Front door glass
Remove an internal upholstery of a door and a plastic sheet.
Remove the gaskets from the inner and outer lower edges of the window opening. On some models, you may have to remove the door mirror (see below) to remove the outer seal.
Remove the rear window guide bolt from the rear edge of the door, then carefully remove the guide and pull it out through the hole in the door.
If required, disconnect the negative battery terminal and wire to the window up/down switch, then lower the window so that the guide channel on the bottom edge of the window pane is accessible through the opening in the door.
Remove the plastic end stop from the guide (pic. 11.8).
Remove the two bolts and remove the lower rail from the door (pic. 11.9. 11.10).
Remove the power window mechanism, if necessary, and tilt the window glass forward so that it can be removed from the outside of the door through the window opening.
Installation is in the reverse order of removal, however, it is necessary to adjust the angle of the lower rail with two screws so that the window operates smoothly, and install the inner door trim.
Rear Door Glass - Sedan and Hatchback Models
Lower the window completely, then remove the door interior trim and plastic sheet.
Remove the gaskets from the inner and outer lower edges of the window opening. Loosen the top guide bolt.
Through the inner panel (lining) door, unscrew the lower bolt (Togh type) securing the window track, then remove the guide from the door. If required, the gaskets can be left on the guide and set aside.
Remove the power window mechanism and tilt the window glass forward so that it can be removed from the outside of the door through the window opening.
Installation is carried out in the reverse order of removal.
Tailgate Sliding Window Glass - Estate Model
The order of work is as indicated in the first two paragraphs of the previous subsection.
Remove the power window mechanism as shown below.
Through the top of the window opening, remove the two upper screws securing the rear window rail.
Through the bottom of the window opening, remove the lower screw securing the rear window guide, then remove the bolt and nut, and remove the window guide upwards through the window opening.
Pull the window pane up through the window opening.
Installation is carried out in the reverse order of removal, however, it is necessary to install the power window mechanism and the inner door trim.
Tailgate Fixed Window Glass - Estate Model
Remove the sliding window as described earlier.
Remove the fixed glass from the frame by pulling forward.
Installation is carried out in the reverse order of removal.
Front door power window
Lower the glass about half way, then remove the door inner lining and plastic sheet.
Secure the glass in the half-open position by substituting a wooden stop under it so that it does not touch the window regulator mechanism.
Drill out the four rivets securing the power window mechanism to the door using a 8.5mm drill bit (pic. 11.14).
Remove the plastic end stop from the guide window.
Remove the two bolts and remove the lower window rail from the door.
On models with electric window lift, disconnect the negative battery terminal, then disconnect the connector from the window motor.
Carefully remove the power window assembly through the door opening.
Installation is carried out in the reverse order of removal, taking into account the following.
Check that the window lifter arms are properly seated in the rails before attaching the power window.
Secure the power window assembly to the door with new rivets.
Adjust the angle of the bottom rail with the two screws so that the window pane runs smoothly.
Install the inner door trim.
Rear door power window
The order of operation here is as indicated in the first three paragraphs of the previous subsection, taking into account the fact that the power window assembly is fixed with five rivets (two upper and three lower) (pic. 11.16).
Then disconnect the negative battery terminal (on electric windows) and motor connector and remove the power window.
Installation is carried out in the reverse order of removal, taking into account the following.
Check that the power window lever is correctly installed in the rail before attaching the power window to the door.
Attach the window regulator to the door with rivets.
Check the operation of the power window mechanism before installing the door lining, then install it.
Visitor comments