21.25 Particulate filter (6) (Z19DT engine (H)) - the arrows indicate the fastening hose clamps 1.2 Differential pressure hoses: 3. Mounting bracket; 4. Mounting bolts; 5. Temperature sensor; 8. Clamp
26. Loosen the union nut, disconnect the temperature sensor (see illustration 21.25) and take him aside. Turn out 2 bolts and remove an arm of fastening of the filter and separate the filter from the central section of system of release of the fulfilled gases. Disconnect the clamp, remove the filter from the holders and remove it.
27. Installation is carried out in the reverse order.
Attention: If the particulate filter has been replaced, the engine management system must be reprogrammed!
Visitor comments