Dismantling
Remove the inner door handle, see section "Removal the door trim" in this chapter.
Remove the triangular strip from the inside. To do this, use a wide screwdriver to carefully push the strip away from the door frame.
Unscrew the mirror base from the inside (three screws), while holding the mirror from the outside.
Slightly lift the external viewing mirror and disconnect the plug connection of the adjustment wires and, accordingly, the mirror heating.
When installing, connect the wire connector and install the mirror on the door frame, then screw it.
When screwing the mirror, make sure that the sealing roller is located above the mirror housing. If necessary, slightly lift the seal and push the housing under it.
Install the triangle bar and the inner handle.
Check the operation of the mirror adjustment and heating.
Tip: For information on the operation and testing of the electric mirror, see chapter "Tools and instruments".
Replacing the mirror glass and mirror motor
Wear work gloves if the mirror is cracked.
Press the mirror glass into the top inside corner.
Take the corner of the mirror located diagonally opposite and remove it from the spring clamps. You can use a plastic wedge for this.
Disconnect the mirror heating wire connector behind the mirror glass. While doing this, hold the riveted contact tabs to avoid damage.
If necessary, unscrew the servomotor from the mirror housing. Disconnect the wire connector.
When installing, insert the mirror glass into the mount and press it so that it is fixed. In this case, also put on work gloves.
Press the mirror glass again from the inside and from above so that the mirror adjustment fasteners fit into the grooves.
Article posted on an online resource www.opelbook.ru
After installation, check the operation.
Visitor comments