Removal and installation
Models with immobilizer
1. Remove the intake manifold.
2. Remove the oil cooler.
3. Disconnect the engine stop solenoid electrical connector from the control unit. Remove the rubber boot from the top of the valve, unscrew the nut and remove the power cable.
4. Unscrew the bolts and remove the control unit from the rear of the fuel pump.
5. Unscrew the solenoid valve and remove the plunger and spring from the fuel pump.
6. Installation is made in sequence, return to removal.
Models without immobilizer
1. Remove the intake manifold.
2. Remove the rubber boot from the top of the valve, unscrew the nut and remove the power cable (indicated by an arrow).
3. Unscrew the solenoid valve and remove the plunger and spring from the fuel pump.
4. Installation is made in sequence, return to removal.
Visitor comments