Headlight
1. Remove the front turn signal.
2. Remove the radiator grille.
3. Disconnect the electrical connector from the rear of the headlight. If working on the left headlight, remove the relay box located in front of the battery.
4. Disconnect the electrical connector from the headlight range control motor.
5. Unscrew the inner and outer headlight mounting bolts.
6. Remove the headlight from the front of the vehicle.
7. If necessary, remove the headlight range control motor by turning it counterclockwise.
(Original source on the website: «OpelBook.ru»)
8. Installation is performed in the reverse order of removal. The protrusion on the headlight should fit into the hole. Check and, if necessary, adjust the headlights.
Front direction indicator
1. Using a screwdriver inserted between the top of the turn signal and the headlight, release the retaining clip and remove the turn signal by sliding it forward along the headlight.
2. Disconnect the electrical connector and remove the turn signal from the vehicle.
3. Installation is carried out in the reverse order of removal.
Front fog light
1. Remove the front bumper.
2. Remove the three bolts, remove the fog light from the bumper and disconnect the electrical connector.
3. Installation is carried out in the reverse order of removal.
Rear light
1. Remove the luggage compartment trim opposite the tail light.
2. Press the tab on the tail light bulb holder and remove the bulb holder from the tail light.
3. Unscrew the fastening nuts (arrows).
4. Remove the tail light from the vehicle.
5. Installation is carried out in the reverse order of removal.
Visitor comments