Replacing the steering gear protective covers (Opel Vectra B)

1. Remove the appropriate tie rod end.

2. Loosen the clamps (arrow) and slide the protective cover along the steering rod.

3. Clean the steering rod and install a new protective boot on it. Secure the boot with new clamps.

4. Install the tie rod end.

5. Check the wheel alignment angles.

[Text copied from an internet website: www.OPELBOOK.ru]

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Checking the article: Pavlovsky Nikolay

Share information:

Opel Vectra B: Steering

Intermediate shaft of the steering column — removal and installation
Steering column — removal and installation
Steering wheel — removal and installation
General information about steering and suspension

Steering gear — removal and installation
Power steering pump (petrol engines)
Power steering pump (1.7L diesel engine)
Power steering pump (2.0L diesel engine)
Bleeding the Power Steering System
Tie Rod End — Removal and Installation

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet