Use of seat belts (Opel Vectra A)

Fastening

Gently pull the belt out of the roller and place it over your shoulder, above your hips, making sure that the belt is not twisted.

Snap the tongue of the belt into the lock. The seat back should not lean back too much. The transverse belt should fit tightly to the body. During the trip, periodically tighten the belt by the shoulder part.

Pregnant women are advised to position the belt as low to the pelvis as possible to reduce pressure on the lower abdomen.

Outerwear prevents the belt from fitting snugly. If the belt passes through pockets of clothing that contain hard or fragile objects, such as pens or glasses, it may cause injury.

Adjusting the top mounting point height:

• do not make adjustments while driving,
• pull the belt out a little,
• press on the mount,
• adjust the height,
• fix it until it clicks. For short people, it is recommended to lower the attachment point. Too high a point significantly reduces the comfort of movement.

Unfastening

To remove the belt, press the red button on the lock. Gently guide the belt into the roller.

Waist belt

Located in the middle of the rear seat: to adjust the length, press the tab up.

Seat Belt Care

All parts of the seat belt system should be checked from time to time and damaged parts should be replaced. After an accident, stretched belts and the activated belt stopper should be replaced with new ones.

It is prohibited to make changes to the design of the belts, their fastenings, the retractor device and the locks.

Make sure that the belts are not damaged or pinched by objects with sharp edges.

Belt Care

Seat belts must be kept clean and dry.

Clean with warm water or a mild soap solution.