The air conditioner cooler cools the air and removes moisture and dust from it, as well as pollen.
The heater in all modes of operation heats the air depending on the position of the temperature controller. The air flow can be adjusted as desired by means of a fan.
Push switch
Temperature control lever
- To the left - decrease in temperature;
- To the right is the rise in temperature.
If the outside air is smoky or smelly: Temporarily turn on maximum cooling.
Air conditioning only works at certain temperatures; at temperatures below approximately +4°C, it switches off automatically.
Air conditioner device
Maximum cooling
Produced at high outdoor temperatures and prolonged exposure to direct sunlight.
The windows must be opened for a short time so that the heated air can escape from the passenger compartment more quickly.
- Enable maximum cooling
- Move the temperature control lever to the left
- Set the fan to full speed
- All blower nozzles open
Maximum cooling should not be switched on for a long time as the air quality deteriorates. Then the air conditioner is adjusted as described below.
Normal cooling for long trips
- Cooling (outdoor air)
- Move the temperature control lever to the left
- Fan optional
- All blower nozzles open
Cooling with temperature combination
- Combination step
- Temperature adjustment lever optional
- Fan as needed
- Open blower nozzles as needed
Set the temperature control lever to the middle position: warmer air rushes into the footwell, and cold air into the upper part of the passenger compartment.
Ventilation without cooling the incoming air
- Turn on ventilation
- Move the temperature control lever to the left
- Fan as needed
- Open all blower nozzles
Heating
- Turn on the heating
- Move the temperature control lever to the right
- Fan as needed
However, do not run the fan at full speed while the engine is warming up.
In this position, heated air is also supplied to the footwell.
During the warm-up phase, the nozzles must be closed. Then, if necessary, point the side nozzles at the side windows to defrost.
Defrosting
- Turn on the mode, to speed up drying at an outdoor temperature above + 4°C, the compressor is turned on
- Move the temperature control lever to the right
- Set the fan to full speed
- Close all blower nozzles
Glove box cooling
When the air conditioner is running, cooled air flows through a special nozzle into the glove box. If there is no need for cooling, the nozzle can be closed.
Important Notes
The air conditioner operates only when the engine is running.
During the operation of the air conditioner, condensed moisture is formed, which accumulates on the lower plane of the car.
When the air conditioner is running, at least one air outlet must be open, as the evaporator may freeze due to lack of air.
Maintenance
To ensure the constant performance of the air conditioner, it must be turned on, regardless of the weather and season, at least once a month for a short time (if possible, only when the outside temperature is above +4°C).
Do not try to troubleshoot yourself, but contact the service station. Since the repair requires certain professional knowledge.
The grilles located in the engine compartment on the right and left and outside in front of the windshield must be free from leaves and snow.
Visitor comments