Removing
1. Disconnect the negative cable from the battery.
2. When withdrawing (if it is needed) grille as described in Section 11, disconnect the appropriate fog lamp wire connector.
3. Apply the handbrake, jack up the front of the vehicle and place it securely on axle stands.
4. When removing the fog lamp from the driver's side, unscrew the mounting screws and remove the plastic lining from the front bumper / fender.
5. Turn off three bolts of fastening and pull out a lamp and electroconducting. Two bolts are clearly visible, and the third is at the top of the lamp.
Installation
6. Installation is carried out in the reverse order, but in conclusion, check the adjustment of the fog lamp.
Adjustment
7. Vertical adjustment of the fog lamps can be done by turning the adjustment screw on the back of the lamp. To do this, remove the plastic cover (driver's side only) from the front bumper/wing (see illustration).
Visitor comments