Side repeater light — removal and installation (Opel Vectra A)

Removal

1. Disconnect the negative cable from the battery.

2. Remove the wheel arch protection as described in Section 11.

3. While working in the engine compartment, disconnect the wire contact and separate the ground cable from the body panel.

4. While working under the wheel arch, press the mounting tabs and pull the light out through the outside of the fender.

5. To remove the light lens, twist it until the retaining clips are released.

6. Check the condition of the rubber O-ring and replace it if necessary.

Installation

7. Installation is carried out in reverse order.