Engine starting system
The F9Q engine is equipped with a Valeo D7 R44 starter.
Removal and installation the starter
Removal
1. Disconnect the battery. The battery is located under the left seat, so you need to remove the floor mat by detaching the clips holding it, then the battery cover A by unscrewing the bolts (figure 3.117).
2. Remove the engine sump guard, disconnect the turbocharger air outlet pipe, front muffler, supports 1 and 2, then catalytic converter 3 (figure 3.120).
3. Disconnect the wiring from the starter, unscrew the bolts that secure it and remove it.
Installation
4. Installation is carried out in the reverse order of removal.
Figure 3.120. Remove the engine sump guard, disconnect the turbocharger air bleed pipe, front muffler, supports 1 and 2, then catalytic converter 3.
Cooling system
Cooling system capacity: 6.4 l.
The cooling system diagram is shown in the figure 3.121.
Figure 3.121. Cooling system diagram:1 - Engine; 2 - Radiator; 3 - Expansion tank; 4 - Heater radiator; 5 - Thermostat housing; 6 - Immersion heater housing (if they exist); 7 - Pipe diameter 16 mm; 8 - Water-oil cooler; 9 - Cooling system pump; 10 - Thermostat; 11 - Air bleed valve.
Visitor comments