Main and connecting rod bearings (Opel Omega B)

Even though the main and connecting rod bearings are subject to replacement during an engine overhaul, they should be carefully inspected as they can provide valuable information regarding the condition of the engine.

Location of identification mark on bearing base



Typical bearing defects



Bearing failure can be due to lack of lubrication, dirt or other foreign particles, engine overload, or corrosion. Regardless of the cause of bearing failure, it must be corrected before the engine is reassembled.

When inspecting the bearings, remove them and arrange them in the same order as they were installed on the engine. This will help identify the corresponding crankshaft journal and make troubleshooting easier.



Foreign particles can enter the engine in a variety of ways. Metal particles can be found in the engine oil as a result of normal engine wear. Small particles can enter the bearings along with the engine oil and easily become embedded in the soft bearing material. Large particles entering the bearing will scratch the bearing or crankshaft journal. The best way to prevent bearing failure due to this is to thoroughly clean all internal engine surfaces and keep them clean when assembling the engine. Frequent and regular oil and filter changes are also recommended.

Insufficient lubrication of the crankshaft journals can be caused by many different reasons, such as high oil temperatures, engine overload and oil leaks.

Driving style also affects the durability of the bearing. A fully open throttle valve at low engine speeds creates a high load on the bearings and squeezes out the oil film from the contact area. These loads lead to cracks in the working part of the bearing, which weakens the bearing and can lead to the antifriction layer being torn off from the steel base.

Short-distance driving causes bearing corrosion because the engine does not reach a stabilized operating temperature, which removes water vapor and corrosive gases. These vapors and gases condense in the engine oil, forming acid and sediment. The acid gets to the bearings along with the engine oil, and bearing corrosion begins.

Incorrect selection of bearings during engine assembly also leads to bearing failure. Bearings installed with preload leave insufficient bearing operating clearance, resulting in a reduced or absent oil layer for lubrication.

(Text copied from this portal OPELBOOK)