Removing
Disconnect the earth cable from the battery.
Disconnect wiring from pump.
Remove fuel lines.
To prevent fuel from escaping, clamp the hoses with clamps or plug them with screws of suitable size. Remove leaking fuel with rags.
Unscrew the fastening clamp and remove the pump together with the rubber gasket.
If the pump will be removed together with the filter and pressure damper, unscrew the bracket (arrow) and a bolt behind the fuel filter. Remove the fuel line from the filter to the distribution line.
Installation
Install and secure the pump. When doing this, pay attention to the correct position of the rubber seal.
If removed, screw on the pressure damper bracket.
Put on the fuel lines.
Connect electrical wiring.
Connect the ground cable to the battery.
Visitor comments