Removal and installation the anti-roll bar (Opel Corsa B)

Removal

1. Loosen the clamp nuts (1) on the right and left sides of the rod and remove the stabilizer.

Stabilizer mounting clamp nuts

Installation

1. Lubricate the rubber support with silicone oil (OPEL No.90 001 800 or 19 48 454). Replace the damaged rubber support.

2. Secure the stabilizer in the area of the flats with clamps to the left and right rods and tighten the new self-locking nuts with force 20 Nm. Observe dimension A between the inner tie rod bolt and the centre of the rubber support.

Clamp installation size

Features of DOHC 1.0 and 1.2 L engines

1. Make sure the stabilizer is in the correct position: the right trunnion should be facing down in the installation position. Dimension A, indicated in the illustration, for DOHC engines 1.0 and 1.2 l should be 110 mm.



Orientation of the stabilizer during installation



(Original posted on the website OPELBOOK.ru)