1. Set the rotary switch for outdoor lighting to position «0» (see chapter «Controls and methods of operation», Section 17) and turn off the ignition. Disconnect the battery (see chapter 5).
2. Using a plastic wedge, wring out the back and front pads (see resist. illustration) from the assembly of directional individual lamps in the front seats - in this case, the plastic wedge must be inserted from the side of the rear clamps.
3. After removing the front cover, use a screwdriver to pry off the microphone on the back of the cover.
4. Insert a plastic wedge under the latches of the glass cover of the luminaire assembly from the rear side (see illustration 22.2) and release the fasteners. Lower the glass cover, release it from the front holders with a small screwdriver and remove.
5. Unscrew the 2 mounting bolts, use a screwdriver to release the assembly base from the holders and remove it (see resist. illustration). Disconnect the wiring connectors.
8. Remove and replace the failed lamp.
7. Installation is carried out in the reverse order. Check the correct functioning of the lamps.
Visitor comments