Engines 1.4, 1.6 and 1.8 liters
1. The sensor is bolted to the front of the sump.
2. Raise the front of the car, remove the lower engine protection panel.
3. Drain the oil, disconnect the wires from the sensor, unscrew the bolts and remove the sensor (see photo).
4. When installing, replace the sensor O-ring.
2.0L engines
5. The sensor is mounted inside the pallet. Remove the bottom section of the pallet (Chapter 2B), unscrew the bolts and remove the sensor by disconnecting the wire.
6. When installing, tighten the fastening screws on the fixing compound.
Visitor comments