1 - Seal
2 - Wiper arms
3 - Nozzles for supplying glass washer fluid
4 - Rubber seal
Layout of elements installed along the lower edge of the windshield (Astra models)
1 - Reflector fixed with two composite nuts
2 - Rubber seal
3 - Reflector panel
4 - Nozzles for supplying glass washer fluid
5 - Wipers
1. Open the hood.
2. Remove the drain chute installed at the rear of the engine compartment.
3. Release the clips and remove the fairing panel installed in front of the windshield (see illustrations The layout of the elements to be removed, installed along the lower edge of the windshield (Astra models) and Layout of elements installed along the lower edge of the windshield (Astra models)). Disconnect washer fluid hoses from nozzles.
4. Remove wiper arms (see chapter Onboard electrical equipment).
5. Remove the two large composite nuts from the driver attachment spindles.
6. Please note that the lower edge of the windshield is attached to the drainage channel with special frames. Carefully release the fairing panel ends from the frames and remove the panel from the vehicle.
7. Installation is carried out in the reverse order.
Visitor comments