Safety hook
Scheme of fastening of safety hook of bonnet lock
1 - Spring
2 - Tongs
3 - Hook
4 - Riveted axle pin
1. The hook support bracket is riveted to the hood - drill out the rivets if necessary.
2. To remove the hook without the bracket, remove its pivot pin (see illustration Scheme of fastening of safety hook of bonnet lock), - the finger is also riveted and must be replaced during installation.
3. Installation is carried out in reverse order.
Lock latch
Adjusting the height of the hood latch
(Article published on the website: opelbook.ru)
1 - Latch
2 — Washer
3 - Spring
4 — Lock nut
X = 40-50 mm
1. Loosen the lock nut, unscrew the latch, remove the washer and spring.
2. Installation is carried out in the reverse order - before tightening the lock nut, adjust the height of the latch (see illustration Adjusting the height of the hood latch).
Lock spring
1. Disconnect the hood lock cable end from the spring, then release the end of the spring from the groove in the front panel, being careful not to damage the paintwork.
2. Installation is carried out in reverse order.
Visitor comments