Door moldings
1. Remove the door upholstery (see Removal and installation of interior trim panels). Loosen the molding screw by inserting a screwdriver through the hole in the inner door panel.
2. To remove the molding from the door, carefully slide it in the appropriate direction - the front door must first be opened.
3. The rear door protective trim is removed by carefully sliding it forward. Open the front door first.
4. Installation is carried out in the reverse order.
Thresholds
Fastening nuts are used to fasten the door sills, as well as plastic clamps of various shapes.
1. Give the corresponding fixture and remove an overlay.
2. Installation is carried out in the reverse order.
Rear side moldings
Removing
The rear side moldings are planted on plastic clips.
1. Carefully remove the molding from the clips.
Installation
1. Check the condition of the clips, - if necessary, replace.
2. Clip on the clip-on trim.
Roof lining
1. With the door open, remove the top rubber seal from the roof.
2. Turn out screws of fastening to a roof of the decorative slip laid over a door.
3. Separate the trim from the rear clips and slide it back.
4. Installation is carried out in the reverse order.
Visitor comments