If the fuel filter mesh is often clogged, remove and flush the tank
Note. It is more convenient to remove an empty tank while working on a lift, overpass or inspection ditch. To remove residual fuel, pump it out through the opened hole in the tank (after removing the connecting hose of the filling pipe).
You will need: key «on 10», end heads «on 10», «at 13», flat blade screwdriver, pliers.
1. Reduce the pressure in the supply system (see Reducing the pressure in the power system).
2. Disconnect the wire from the terminal «minus» battery.
3. Loosen the clamp that secures the connecting hose of the filler pipe to the fuel tank nozzle..
4.... and disconnect the hose from the nozzle, at the same time removing the clamp from the hose so as not to lose it.
5. Squeeze the latch on the air tube..
6.... and disconnect the tube from the fitting of the fuel tank filler pipe.
7. Press the retainer of the pressure pipe tip..
8.... and disconnect the pipeline from the fuel supply line.
9. Similarly disconnect the pipeline of an adsorber of system of catching of steams of fuel.
10. Place a secure support under the tank.
11. Turn out bolts of fastening of two collars of a suspension bracket of a fuel tank..
12.... remove the clamps, removing their retainers from the brackets on the body, remove the support and lower the fuel tank slightly, gradually moving it down and to the right.
13. Press the latch..
14.... and disconnect the wiring harness block from the fuel module.
15. Completely remove the fuel tank.
16. Install the fuel tank in the reverse order of removal.
17. After connecting the pipelines and the fuel pump wiring harness, fill the tank with gasoline, start the engine and check the tightness of all pipeline connections.
If you need to remove filling pipe fuel tank, do the following.
1. Remove the right rear wheel and place the vehicle on a secure stand.
2. Remove the right rear fender liner (see Removal and installation of fender liner).
3. Loosen the clamp that secures the connecting hose to the inlet pipe..
4.... and disconnect the hose from the fill pipe, while removing the clamp from the hose so as not to lose it.
5. Squeeze the latch on the air tube..
6.... and disconnect the tube from the fitting of the fuel tank filler pipe.
7. Turn out bolts of fastening of a bulk pipe to an arm on a body sidewall …
8.... and to the right rear spar.
9. Open the manhole cover of the fuel tank filler pipe, unscrew the filler pipe plug..
10.... remove the filling pipe from the rubber seal of the hatch..
11.... and remove it.
12. Install the fuel tank filler pipe and all removed parts in the reverse order of removal.
Visitor comments