Attention! If the battery is disconnected from the mass when the selector is in position P, then it is automatically fixed. To unlock the selector manually, remove the floor section cover and use a screwdriver to press the lock lever on the left side (see photo).
1. Move the selector to position P.
2. Remove the battery and battery tray.
3. Pull on the cable sheath bracket: and remove the cable from the bracket (see photo).
4. Make sure that the selector is in position P and move the gear selector lever forward to the parking position (see photo). Lock the cable sheath by pushing the clip until it clicks into place.
5. Install the battery and check the operation of the selector. Repeat the adjustment procedure if necessary.
Visitor comments