Carburetor models
1. Remove the air filter (Section 3).
2. Guided by Fig. 6.16, release the spring clip (A).
3. Release the throttle cable adjustment, then spread the bezel (IN) while throttle lever (4) won't go against throttle limiter without parts (5) And (6) turned against each other. Fasten the bezel in this position.
4. Adjust the throttle control pedal so that there is no free play.
5. Slowly depress the throttle pedal until the downshift mechanism (kickdown) will not press fully. Install spring clip (A).
6. Install the air filter (Section 3).
Fuel injected models
7. Guided by Fig. 6.17, release the safety brace (IN).
8. Depress the throttle pedal until it touches the downshift mechanism (kickdown) (photo).
9. Spread the bezel (6) until the throttle lever is against the wide open throttle stop, then install the spring clip (IN).
10. With the throttle pedal released, adjust it so that there is no free play.
11. Loosen the spring clip (A).
12. Slowly depress the throttle pedal until the downshift mechanism (kickdown) will not press fully. Install spring clip (A).
Visitor comments