Ventilation nozzle
Carefully pry off the appropriate nozzle on the instrument panel using a screwdriver and a piece of cardboard under the tip of the screwdriver so as not to damage the surface, then pull out the nozzle.
When installing, simply press the nozzle and insert it into the housing on the panel until the tabs click into place in the slots.
Ventilation nozzle housing located on the driver's side - removal and installation
Remove the steering column cover as directed in chapter 10.
Remove the instrument panel bezel as directed in chapter 12.
Remove the vent nozzle as described earlier.
Remove the rotary light switch as directed in chapter 12.
Remove the top screw securing the nozzle body and the bottom screw.
Carefully pull out the housing clip, which is accessed from the right side.
Carefully pull the housing out of the instrument panel and disconnect the wires.
Installation is carried out in the reverse order of removal.
Passenger side vent housing - removal and installation
Remove the glove box as directed in chapter 11.
Remove the vent nozzle as above.
Remove the top screw of the case and the bottom screw, then carefully pull out the case.
Installation is carried out in the reverse order of removal.
Visitor comments