Remove the filter.
Remove the windshield wipers as directed in chapter 12, if it is needed.
Remove the windshield fairing panel.
Disconnect the fan motor wire, then remove the wiring harness from the air filter housing and feed the wire through the hole in the housing.
Similarly, disconnect the vacuum tubes from the front side of the casing, noting their location).
Loosen the four screws (two on the front and two on the back) and, moving the air filter housing, remove it.
Release the two clips and remove the fan motor top cover.
Disconnect the two fan motor wires from the fan motor resistor, then unscrew the two motor screws and carefully pull out the assembly.
Installation is in the reverse order of removal, but note the following.
Check that the wiring and vacuum tubes are securely connected and properly located.
Install windshield wipers (chapter 12).
Heater fan motor resistor - removal and installation
Remove the air filter to expose the resistor.
Remove one screw, then disconnect the wiring and remove the resistor.
Installation is carried out in the reverse order of removal.
Visitor comments