Note: The main section consists of two cables and an equalizer.
1. Disconnect the front section of the drive cable from the equalizer (see section 13).
2. Support the front wheels with wheel chocks, jack up the rear of the car and place it on supports. For ease of work, you can remove the rear wheels. Disconnect the parking brake cables from the actuator levers and rear wheel calipers (see Section 8).
3. Unscrew the bolt securing the removable cable holder (see accompanying illustration), release the cables from the remaining holders on the bottom of the car and remove the cables with the equalizer.
14.3 Fastening of the main section of the parking brake drive; the cable clamps are indicated by arrows: 1. Removable holder; 2. Non-removable holders; 3. Cable
[Article posted on Internet portal opelbook.ru]
4. Installation is performed in the reverse order of removal. Make sure the cable is installed correctly - the gray rod should be located on the right side. Do not forget to install new torso end clamps on the actuator lever.
Visitor comments