Lamp replacement
Carefully pry the turn signal housing out of the trim strip with a small screwdriver.
Unlock and disconnect the wire connector.
Pull the lamp housing out of the socket with a twisting motion.
Remove the glass base bulb from the socket and insert a new bulb.
Mount the lamp housing and press it into the trim strip until it is inserted into the groove.
Left: turn signal housing (2) can be removed with a screwdriver (1) as shown here.
On right:dismantled turn signal. The numbers indicate:
1 - wire connector;
2 - lamp holder;
3 - incandescent lamp;
4 - turn signal housing.
Left: a screwdriver can be pressed from the decorative strip housing of the side turn signal lamp.
On right: the individual parts of the side turn signal are shown here. The numbers indicate:
1 - turn signal housing;
2 - connector;
3 - lamp holder;
4 - lamp with glass base.
Visitor comments