Contents: Removal ⬇ Installation ⬇
Instrument panel
Removal
1. Disconnect the ground cable from the battery. Warning! After disconnecting the battery, wait at least 1 minute to allow the airbag control system capacitors to discharge.
2. Remove the steering wheel.
3. Disconnect the wire from the airbag.
The article was published on the website: OPELBOOK
4. Remove the windshield wiper and turn signal switches.
5. Remove the ignition switch.
6. Remove the immobilizer control unit.
7. On the driver's side, remove the lower instrument panel trim.
8. Disconnect and remove the air duct.
9. Remove the radio.
10. Remove the heater control unit.
11. Remove the air ducts.
12. Remove the glove box.
13. Remove the center console.
14. If equipped, remove the passenger side airbag.
15. Remove the interior trim of the front pillars.
16. Remove the cover from under the panel that covers the coolant pipes.
17. Remove the windshield air vents from the front of the panel.
18. Remove the side footwell trims.
19. Remove the left and right side heating ducts.
20. Disconnect the bracket securing the wire harness to the bracket.
21. Lift the wiring harness out of the bracket.
22. Unscrew the lower (arrows) and upper screws securing the wiring harness bracket located under the instrument panel.
23. Disconnect the electrical harness connector located on the right side of the engine compartment.
24. Remove the bolt and disconnect the ground bus from the base of the front pillar. Also disconnect the ground bus from the steering column bracket.
25. Remove the ABS hydraulic modulator, then disconnect the wiring harness electrical connector and remove the harness into the vehicle interior.
26. Remove the fuse box cover, unscrew the bolt and remove the box.
27. Unscrew the bolts securing the instrument panel to the engine compartment bulkhead and remove it along with the electrical wires.
Installation
Installation is carried out in the reverse order of removal.
Visitor comments