General characteristics
Type (all models) - Shafts of unequal length, with a CV joint at each end. Some models are equipped with a vibration damper mounted on the right shaft.
Driveshaft CV Joint Lubrication Specification - See Section "Lubricants and fluids" in Chapter "Weekly checks".
Tightening torques, Nm
Front wheel hub nut*
- Stage 1 - 130
- Stage 2 - Completely loosen the nut
- Stage 3 - 20
- Stage 4 - Tighten the nut an additional 80°*
intermediate shaft support bearing:
- Bracket to cylinder block - 55
- Bearing flange to bracket - 18
The lower arm to the ball joint of the suspension strut - 70
Wheel bolts - 110
* See Chapter 2.
Visitor comments