Removing
Remove the dipped beam bulb.
Remove the protective cap (arrow).
Press the bulb down while reconnecting the wiring harness3.
Remove the incandescent lamp.
Disconnect harness connector 2.
Installation
Install the low beam bulb.
Connect the wire harness connector.
Insert incandescent bulb with wire harness connector.
Note. Pay attention to the correct mounting position.
Install the protective cap.
Insert protective cap and secure.
Xenon headlight bulb replacement
Removing
Remove the headlights.
Attention! The elements of the xenon dipped beam must not be touched when the dipped beam is on. Turn off the ignition and light switch. Headlight harness center connector must be disconnected.
Remove the xenon headlight ignition module.
Unlock and remove the protective cap of the xenon headlight.
Unscrew the xenon lamp ballast 1.
Remove the xenon lamp 3x unscrew the screw from the retaining ring 1.
Remove the snap ring.
Remove xenon bulb 2.
Installation
Install a xenon lamp.
Note. Pay attention to coding.
Insert the circlip, tighten the circlip screw.
Install the xenon headlight ignition module.
Connect the xenon lamp ballast and fix.
Install the protective cap of the xenon lamp.
Adjust headlights.
Check lamp operation.
Visitor comments