Main Astra Corsa Insignia Kadett Omega Vectra Zafira Others Articles

Insignia A (2008-2017)

Replacing the front bumper beam (Opel Insignia A)

1. Remove the front bumper trim.

2. Unscrew the four bolts (1) securing the front bumper beam.

Note: Tightening torque: 22 Nm.

Note: Tightening torque: 22 Nm.

3. Remove the front bumper beam (2).

(Text was copied from the portal www.OpelBook.ru)

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Checking the article: Zinoviev Kirill

Share information:

Previous articles

Opel Insignia A: Exterior

Next articles

Replacing the front bumper center support bracket
Replacing the front bumper energy accumulator
Replacing the front bumper trim
Front bumper device
General information

Replacing the lower beam of the front bumper
Rear bumper device
Replacing the rear bumper trim
Replacing the rear bumper energy accumulator
Replacing the rear bumper beam
Replacing the lower brackets of the rear bumper trim

See similar ones from other Opel car manuals:
▶ Replacing constant velocity joints of front wheel drives Opel Astra J (2009-2015, petrol)
▶ Removal and installation the front beam holder (impact… Opel Corsa C (2000-2006, petrol)
▶ Replacing the front camshaft seals of a 16-valve engine Opel Kadett E (1984-1995)
▶ Front bumper — removal and installation Opel Omega B2 (1999-2003)
▶ Replacing the front brake pads Opel Vectra B (1995-2002, petrol)

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet

We want your visit to be comfortable 🤝! We use cookies 🍪 to make that happen.