Replacing the rear bumper trim (Opel Insignia A)

Sedan/hatchback

1. Remove the rear signal lights.

2. Unscrew the six bolts (1) securing the rear bumper trim.

Note: You will need to pry up the rear mudguard to gain access to the mounting bolts.

3. Remove the fasteners (2) from the rear bumper trim.

4. Disconnect all electrical connectors, then carefully pull the rear bumper trim (3) at the sides to release it from the body panels and remove it from the vehicle.

5. Installation is carried out in the reverse order of removal.

Note: If necessary, swap components from the old to the new rear bumper trim.

Station wagon

1. Remove the side wedge-shaped stops of the luggage compartment door from the body.

2. Loosen the screws of the right and left side guides, then move the guides forward and remove.

3. Loosen the six bolts (1) securing the rear bumper trim.

Note: You will need to pry up the rear mudguard to gain access to the mounting bolts.

4. Remove the fasteners (2) from the rear bumper trim.



[Material published on the website: OPELBOOK]

5. Disconnect all electrical connectors, then carefully pull the rear bumper trim (3) at the sides to release it from the body panels and remove it from the vehicle.

6. Installation is carried out in the reverse order of removal.

Note: If necessary, swap components from the old to the new rear bumper trim.