22.1. To engage reverse gear on the manual transmission gearshift lever, press the locking ring
The car starts moving in first gear or reverse gear. Press the clutch pedal to the floor and move the gearshift lever to one of these positions. To engage reverse gear, approximately 3 seconds after disengaging the clutch, press the locking ring on the gearshift lever and only then engage the gear.
Attention: Reverse gear can only be engaged after the vehicle has come to a complete stop!
If the gear does not engage, return the lever to neutral, briefly release and re-depress the clutch pedal and try to engage the gear again.
Release the parking brake - the corresponding indicator lamp on the instrument panel should go out (see Section 16).
While smoothly releasing the clutch pedal, simultaneously slowly press the gas pedal.
Before shifting the gearshift lever to the next position, fully depress the clutch pedal. After shifting the gear, slowly and smoothly release the clutch pedal.
Note: If you frequently change gears without fully disengaging the clutch, the manual transmission may quickly fail.
The choice of gear must correspond to the driving conditions, the condition of the road surface and is largely determined by the driver's experience. An experienced driver drives a car at the maximum possible speed for specific driving conditions, but at the same time it is necessary to constantly monitor speed limit signs.
Caution: Never attempt to exceed the maximum speed limit specified for a particular gear (see Specifications)!
Do not keep your foot on the clutch pedal while driving. For faster acceleration, fully accelerate the car in the current gear before shifting to a higher gear. If the engine starts to jerk when you reduce the speed by releasing the gas pedal, shift to a lower gear. Avoid abruptly pressing the gas pedal, as well as abruptly shifting to a lower gear when driving on a slippery road.
Note: When leaving the car in a parking lot, it is recommended to engage first/reverse gear in addition to the parking brake!

Visitor comments