Removal and installation the rear seat (Opel Corsa B)

Corsa model

1. Remove the seat hinge covers (1).

Seat hinge covers



2. Disconnect both hinge strips and remove the rear seat.

3. Fold the rear seat forward and remove the safety pins (1) from the right and left of its guide.

Safety pins



4. Use a screwdriver to release the clips on the left and right seat guides and remove the guides from the hole in the body.

Original posted on the website (Opelbook.ru)

Disconnecting the retainer



5. Remove the seat back from the guide in the luggage compartment.

Composite rear seat backrest (models from 03.1993 to 08.1995.)

1. Remove the trim (1) from the rear seat back on the left and right sides. Remove the upholstery in the area of the hinges (2), releasing the fasteners (3).

Pads (1), loops (2) and fasteners (3) for the back of the rear seat



2. Remove the screws securing the left, right and central hinges and remove the seat back.

Hinge fastening screws



3. Installation is performed in the reverse order of removal. Tighten the mounting bolts with force 20 Nm.

Composite rear seat backrest (models from 05.1995.)

1. Remove the trunk lid.

2. Fold half of the seat back forward.

3. Remove the screws securing the side trim and hinges to the wheel arch cover.

4. Fold back half of the backrest, detach it from the middle support and remove it.



5. Do the same with the other half of the back.

6. Installation is performed in the reverse order of removal. Tighten the mounting bolts to the middle support with force 20 Nm, and to the wheel arch casing - with force 30 Nm.

Model Tigra

1. Unscrew the bolts securing the front seat cushion holders on the right and left. Release the frame from the holders.

Seat cushion mount bolts



2. Release the frame from the rear seat cushion holders on the right and left. Remove the seat cushion.

3. Disconnect the seat belt guide plate (1) on both sides. Remove the holder (2) on both sides. Remove the rear seat back.

Guide plate (1) and seat belt holder (2)



4. Install the seat cushion into the holders. Secure the front holders.

5. Tighten the seat back bolts firmly 30 Nm.