Removing
Remove the heater control unit and disconnect the corresponding rod (see Section Removal and installation of the heating control unit).
Draft of a drive of the shutter of ventilation and an obduv of a windshield
1. Remove the pocket under the right side of the instrument panel.
2. Disconnect the rod from the support (1) and lever (2). Remove the rod from the guide (3) on the air distributor housing at the bottom right.
Support (1) and lever (2) thrust
Foot well damper drive rod
Disconnect the rod (1) from the air distributor housing at the bottom right and disconnect it from the lever (2). Take out the pull.
thrust (1) and air distributor lever (2)
Damper control rods (temperature control)
1. Remove the pocket under the right side of the instrument panel.
2. Disconnect the link (2) to the right of the fan motor housing and disconnect the inner cable. Disconnect and take out draft at the left from the holder (1).
Holder (1) and thrust (2)
3. Installation is carried out in the reverse order. Install rods according to the illustration.
Ropes (1, 2, 4, 5) and connector (3) control unit
№ | Damper rod | Color |
1 | foot wells | Grey |
2 | Ventilation and blowing of a windshield | Brown |
4 | air duct | Black |
5 | Ventilation | Blue |
When laying the rods, do not bend them with a radius of less than 60 mm.
Visitor comments