Removal and installation the gas pedal (Opel Astra H)

1. Fuel supply to the engine cylinders is controlled by the ECM, which receives an electrical signal from the gas pedal position sensor installed on the pedal assembly. The pedal is removed together with the sensor. If the pedal assembly fails, it is not repaired in a regular workshop and is replaced completely.

2. In the car's interior, in order to provide access to the pedal assembly, release the fastener and remove the left (driver's license) lower instrument panel trim cover (see Chapter 11, Section 34), if necessary, fold back the carpet covering of the passenger compartment floor.

3. Loosen the mounting nuts and remove the pedal assembly from the engine compartment bulkhead (see accompanying illustration). Slide the locking element on the connector to disconnect the electrical wiring from the gas pedal position sensor/fuel feed sensor.



4. Installation is carried out in reverse order.

(Material copied from this website OPELBOOK)