1. To facilitate subsequent installation, mark with adhesive tape the position of the power window handle with the window closed.
2. Power window handle (with appropriate equipment) can be removed with a special tool (see resist. illustration) or screwdrivers.
3. Press out the wire clip (see resist. illustration) and remove the handle from the shaft, then remove the plastic washer. If at the same time the wire clip was completely squeezed out of the handle, thread it back into the 8th groove.
4. To install the handle, put a plastic washer on the axle, then with light strokes of the palm, put the handle on, while the wire clip should be fixed on the handle axle.
Visitor comments