Thermostatic fan switch
Checking, removing and installing
The switch is checked as described in the previous section.
The switch is located at the bottom right side of the radiator. The engine and radiator must be cold when removing it.
It is necessary to partially drain the liquid from the cooling system (approximately to the switch), or have a plug for the hole under the switch.
Disconnect the negative battery terminal.
Disconnect the wires from the switch.
Carefully unscrew the switch and remove the sealing ring.
Installation is carried out in the reverse order of removal, however, it is necessary to install a new sealing ring and fill the cooling system.
After installation, start the engine and bring it to normal operating temperature, then let the engine run and check the operation of the fan.
Visitor comments