Open large image in new tab →
E63 | Instrument lighting |
F11 | Fuse in the fuse box |
F19 | Fuse in the fuse box |
H27 | Alarm buzzer |
K20 | Electronic ignition coil control unit |
K57 | Muttec engine and injection computer |
K58 | Fuel pump relay |
K61 | Motronic injection computer |
K68 | Fuel injection relay |
K83 | All-wheel drive control unit |
L1 | Ignition coil |
L2 | Ignition coil (direct ignition) |
M21 | Fuel pump |
M33 | Idle solenoid valve |
M66 | Idler stepper motor «uu» |
P13 | Ambient temperature sensor |
P23 | Intake manifold vacuum sensor |
P29 | Intake manifold air temperature sensor |
P30 | coolant temperature sensor |
R32 | Heated lambda probe |
R33 | Lambda probe |
R34 | Throttle Potentiometer |
R35 | Crankshaft position and speed sensor |
R44 | Air pressure sensor |
R46 | Knock sensor |
R47 | Hall Sensor |
R61 | Oil temperature sensor (on the gearbox) |
S53 | 1st gear switch |
S89 | Seat belt switch |
S117 | Hydraulic pressure switch |
U14 | Dual indicator |
V14 | knock signal filter |
V15 | Exhaust Gas Recirculation Booster |
X5 | 14-pin connector (dashboard and engine) |
X6 | 51 pin connector (instrument panel and body) |
x8 | 2-pin connector (dashboard and search system Multec) |
x9 | 6-pin connector (dashboard and Motronic/Multec injection system) |
X11 | 6-pin connector (dashboard and Multec injection system) |
X13 | Diagnostic connector (10 cont.) |
X16 | 5-pin connector (dashboard) |
X38 | 2-pin connector (body and fuel pump) (except 4x4 Calibra) |
X61 | 1-pin connector (engine and fuel injection system Motronic) |
X62 | 2-pin connector (Multec engine and fuel injection systems) |
Y7 | fuel injectors |
Y11 | Hot start solenoid valve |
Y12 | Load Regulator Pressure Switching Valve |
Y18 | Exhaust gas recirculation solenoid valve |
Y32 | Fuel burner |
Y33 | Distributor |
Y34 | Fuel tank vent valve |
Y44 | All-wheel drive solenoid valve |
Visitor comments