Warning! When installing the pulley, a new bolt must be used.
Removing
1. Raise the front of the car and secure it on stands. Remove the right wheel.
2. Remove the auxiliary drive belt.
3. Loosen the crankshaft pulley bolt. To prevent the crankshaft from turning, lock it by engaging any gear and pressing the brake.
4. Unscrew the bolt and remove the crankshaft pulley. Check the condition of the crankshaft oil seal and replace if necessary.
Installation
1. Install the pulley on the crankshaft. At the same time, the groove in the pulley (indicated by an arrow) align with the crankshaft key.
2. Install the crankshaft pulley bolt.
3. Secure the crankshaft from turning and tighten the crankshaft pulley bolt in several steps.
4. Install the auxiliary drive belt.
5. Install the wheel and lower the car.
Visitor comments