The starter is mounted on the cylinder block on the rear side of the power unit.
You will need: ring wrenches «on 10», «at 13».
1. Disconnect the wire from the terminal «minus» battery.
2. Loosen the power wire fixing nut…
3.... and remove the wire from the contact bolt of the traction relay.
4. Turn away a nut of fastening of a control wire of the traction relay..
5.... remove the control wire from the contact bolt of the traction relay and take the removed wires to the side.
6. Loosen the fastening nut «mass» wires.
7. Remove «mass» wire from the bottom stud of the starter and take it to the side.
8. Having unscrewed the upper bolt..
9.... and the lower stud of the starter to the engine..
10.... remove the starter.
11. Install the starter in the reverse order of removal.
Visitor comments